Bonjour je vien d'acheter une carte mere j'ai tout installer et j'ai mis mandriva free 2007 mais le probleme c que je n'arrive pas a installer la wifi intergrer a la carte mere et pourtan sur le cd il y a un dossier linuxdrivers et je vais dans le dossier VIA_lan et la il y a un dossier nommer 64bit un fichier texte linux.txt et une archive rhinefet.tgz donc je regarde dans le fichier texter et comme par azard c en anglai mais j'ai essayer de comprendre les commande a taper et je ne comprend rien alor si vous pouvier m'aider se serai cool voila la parti du fichier texte ou il explique comment installer :


Installation
============
Please enter the following commands at the UNIX prompt. Remember, UNIX is
case sensitive.

1) Create a temporary directory:
mkdir /temp

2) Change to the temporary directory:
cd /temp

3) Copy driver (rhinefet.tgz) from DOS disk, (mcopy below is one tool in
mtools, if you didn't install mtools, you can type
'mount -t msdos /dev/fd0 /mnt' and use 'cp /mnt/rhinefet.tgz /temp'
command to copy the driver to the temporary directory):
mcopy a:rhinefet.tgz .

4) untar the archive file:
tar xzvf rhinefet.tgz
cd rhinefet

5) Compile the driver source files and it will generate rhinefet.o, and
copy it to correct driver installation path (The installation directory
is different in different kernel versions. In 2.4.x/2.6.x kernel, the path
is /lib/modules/KERNEL_VERSION/kernel/drivers/net/, and in 2.2.x kernel,
the path is /lib/modules/KERNEL_VERSION/net/, the KERNEL_VERSION (see
above) means the kernel version of your Linux distribution. If you don't
know your kernel version , please run 'uname -r' command in command
line. The kernel version will look like '2.2.16', '2.4.2-2smp' etc.) :
make install

6) Check configuration file (/etc/modules.conf or /etc/conf.modules or
/etc/modprobe.conf, it depends on your Linux distribution) for loading
kernel modules. Make sure the first line below is appeared in the
configuration file, where # is the interface number (eg: alias eth0
rhinefet). If you need to set the driver options, below second line is
an example to set the NIC to 100Mbps fullduplex mode (remember to unmark
the line if it is put in the configuration file).
alias eth# rhinefet
#options eth# speed_duplex=2

7) Reboot now:
shutdown -r now

8) Install your driver module (If the driver module is in the wrong place,
an error message will appear, and say that can't find the driver
module):
insmod rhinefet.o

9) Use ifconfig command to assign the IP address, where # is network
interface number:
ifconfig eth# <IP>

10) Check the interface works:
ping <remote_host_IP>



voila pour info la carte c une assus p5v-vm dh



voila et merci d'avance