[DEBIAN11] Bond avec SYSTEMD ne prend pas en compte le mode 802.3ad

Bonjour,
J'utilise systemd pour configurer le réseaux sur le serveur.

Config ci dessous:

Code:

---

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

cat /etc/systemd/network/bond0.netdev # bond0.netdev file # A bond device is an aggregation of all its slave devices [NetDev] Description=Agregation of all physical network card Name=bond0 Kind=bond   [Bond] Mode=802.3ad # Kernel Bonding Driver Options => mode 802.3ad TransmitHashPolicy=layer2+3 # Kernel Bonding Driver Options => xmit_hash_policy # lacp_rate slow => LACPDUs every 30 seconds # lacp_rate fast => LACPDUs every 1 seconds LACPTransmitRate=fast # Kernel Bonding Driver Options => lacp_rate AdSelect=count # Kernel Bonding Driver Options => ad_select MinLinks=0 # Kernel Bonding Driver Options => min_links MIIMonitorSec=1s

---

Mais pour une raison que je ne connais pas, le bond est en mode "load balancing":

Code:

---

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25

cat /proc/net/bonding/bond0 Ethernet Channel Bonding Driver: v5.10.0-13-amd64   Bonding Mode: load balancing (round-robin) MII Status: up MII Polling Interval (ms): 1000 Up Delay (ms): 0 Down Delay (ms): 0 Peer Notification Delay (ms): 0   Slave Interface: enp6s0 MII Status: up Speed: 1000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: 2c:4d:54:44:4e:e8 Slave queue ID: 0   Slave Interface: enp5s0 MII Status: down Speed: Unknown Duplex: Unknown Link Failure Count: 0 Permanent HW addr: 2c:4d:54:44:4e:e7 Slave queue ID: 0

---

Comment prendre en compte le mode que je définis?

Cordialement,
Pierre

Bonjour,
Il n'a aurais pas un soucis avec les interfaces réseau ??

Code:

---

1 2 3 4 5 6 7 8 9 10 11 12

cat /proc/net/bonding/bond0 ... Slave Interface: enp5s0 MII Status: down Speed: Unknown Duplex: Unknown Link Failure Count: 0 Permanent HW addr: 2c:4d:54:44:4e:e7 Slave queue ID: 0

---

Mon fichier bond0

Code:

---

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79

/# cat /proc/net/bonding/bond0 Ethernet Channel Bonding Driver: v5.15.19   Bonding Mode: IEEE 802.3ad Dynamic link aggregation Transmit Hash Policy: layer2 (0) MII Status: up MII Polling Interval (ms): 100 Up Delay (ms): 0 Down Delay (ms): 0 Peer Notification Delay (ms): 0   802.3ad info LACP active: on LACP rate: fast Min links: 0 Aggregator selection policy (ad_select): stable System priority: 65535 System MAC address: 68:05:ca:39:bb:76 Active Aggregator Info: Aggregator ID: 1 Number of ports: 2 Actor Key: 9 Partner Key: 10 Partner Mac Address: 64:d8:14:5d:9f:62   Slave Interface: eth0 MII Status: up Speed: 1000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: 68:05:ca:39:bb:76 Slave queue ID: 0 Aggregator ID: 1 Actor Churn State: none Partner Churn State: none Actor Churned Count: 0 Partner Churned Count: 0 details actor lacp pdu: system priority: 65535 system mac address: 68:05:ca:39:bb:76 port key: 9 port priority: 255 port number: 1 port state: 63 details partner lacp pdu: system priority: 128 system mac address: 64:d8:14:5d:9f:62 oper key: 10 port priority: 128 port number: 1 port state: 61   Slave Interface: eth1 MII Status: up Speed: 1000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: 68:05:ca:38:25:3f Slave queue ID: 0 Aggregator ID: 1 Actor Churn State: none Partner Churn State: none Actor Churned Count: 0 Partner Churned Count: 0 details actor lacp pdu: system priority: 65535 system mac address: 68:05:ca:39:bb:76 port key: 9 port priority: 255 port number: 2 port state: 63 details partner lacp pdu: system priority: 128 system mac address: 64:d8:14:5d:9f:62 oper key: 10 port priority: 128 port number: 2 port state: 61

---

Ma conf Bond0

Code:

---

1 2 3 4 5 6 7 8 9 10 11

IFNAME[0]="bond0" BONDNICS[0]="eth0 eth1" BONDMODE[0]="802.3ad" IFOPTS[0]="lacp_rate fast | miimon 100" IPADDRS[0]="xx.xx.xx.xx/24" #USE_DHCP[0]="" #DHCP_HOSTNAME[0]="" #IP6ADDRS[0]="" #USE_SLAAC[0]="" #USE_DHCP6[0]=""

---

hth,