1 pièce(s) jointe(s)
programmation du pic16f887 pour controle un thermometre numerique
Bonjour je suis un jeune étudiant et lors de nos études et réalisation nous avons décidé de réaliser un thermomètre électronique commandé via un pic 16f887 mais je n arrive pas a trouve le programme pour le faire fonctionne normalement je programme avec mikro c for pic et j aimerai avoir le bon programme.
j'utilise un capteur de température LM35 raccordé à l’entrée RA0/AN du pic avec un afficheur LM016L. en effet l'afficheur affiche bien thermomètre électronique pendant 6ms comme indique dans le programme et après il plante .
voila mon code
Code:
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71
| sbit LCD_RS at Rb4_bit;
sbit LCD_EN at Rb5_bit;
sbit LCD_D4 at Rb0_bit;
sbit LCD_D5 at Rb1_bit;
sbit LCD_D6 at Rb2_bit;
sbit LCD_D7 at Rb3_bit;
sbit LCD_RS_Direction at TRISb4_bit;
sbit LCD_EN_Direction at TRISb5_bit;
sbit LCD_D4_Direction at TRISb0_bit;
sbit LCD_D5_Direction at TRISb1_bit;
sbit LCD_D6_Direction at TRISb2_bit;
sbit LCD_D7_Direction at TRISb3_bit;
float temp_res;
int volt;
char txt[10];
float b=40;
int i;
void main() {
Lcd_Init();
Lcd_Cmd(_LCD_CURSOR_OFF);
Lcd_Cmd(_LCD_CLEAR);
trisa=0xff;
trisb=0;
lcd_out(1,1,"THERMOMETRE ");
lcd_out(2,1,"ELECTRONIQUE ");
delay_ms(600);
Lcd_Cmd(_LCD_CLEAR);
delay_ms(1000);
while (1){
adcon1=0b10000000;
adcon0=0b10000101;
volt = ADC_Read(0);
temp_res=(0.488 * volt);
FloatToStr(temp_res, txt);
lcd_Out(2, 4, txt); lcd_out(1,1,"LA TEMPERATURE");
}
} |
voila la réalisation du montage :
Pièce jointe 117692